RA5 Deluxe Universal Battery Charger/ Analyzer/ Conditioner

for use with PowerFilm units, 14.4V, 800mA

• Supports Lithium Ion, Lithium Polymer, NiMH, NiCad batteries of any shape
• Battery holders included (2/3 AAA, 2/3/4 AA, 4 C, and 4 D).
• Additional battery holders can be purchased to charge additional batteries up to 7.2V
• Universal design to accommodate a wide variety of batteries for cell phones, cameras, camcorders, two-way radios, or laptops
• Analyze and condition battery packs and digitally display capacity
• Fast charger with 800 mA charging current for NiMH and NiCad batteries and 400 mA charging current for Lithium Ion batteries
• Includes 12V cigarette lighter adapter plus AC adapter
• Digitally display voltage, time, and capacity throughout the charge and discharge process

Frequently Asked Questions

How do I know if it is working? You can check the PowerFilm Rollable Battery Charger with a voltmeter.

Will this product drain my battery at night? No. It has a built-in blocking diode to protect against reverse draining of current.

Can I leave it outside permanently? The PowerFilm Rollable Battery Charger can be left outside permanently if maintained properly. It must be properly secured to avoid damage from high winds. Terminals should be kept clean and firmly connected.

What if the product gets wet? The product is waterproof.

How do I clean the product? Use a damp cloth with a mild soap solution.

What if the product goes under water? Wipe the product with a dry cloth and allow the product to dry before use. Avoid having the product completely submerged for an extended period of time.

Can I leave it outside in freezing temperatures? Yes.

If I need more power can I connect several of these together? How? Yes, it is acceptable to connect several PowerFilm Rollable Battery Chargers in parallel. Connect using the RA-6 PowerFilm Rollable Daisy Chain Accessory. Connect chargers up to a combined output of 20 Amps.

Can I use an extension cord? You can use the RA-7 PowerFilm 15 ft. Extension Cord accessory complete with matching marine-grade connectors. Total cord length greater than 30 feet likely will result in reduced power output.

Do I need to disconnect this charger when I start my vehicle or when I recharge the battery with an auxiliary power source? You do not need to disconnect the rollable solar panel. You need to disconnect any battery charger pack accessory that is connected to the solar panel.

Do I need a charge controller? A charge controller is used to prevent overcharging. As a general recommendation, a charge controller should be used if the current output of the solar panel, in Amps, is more than 1 percent of the battery capacity, in Amp-hours. For example, a charge controller would be recommended if the R15-1200 (with 1.2 Amps) were connected to a battery that is less than 120 Amp-hours. Consult the battery manufacturer for complete battery information and recommendations.

Powering this unit from the sun requires a RA-2 Cigarette Lighter Socket and two PowerFilm R15-300s or one PowerFilm R15-600. A PowerFilm R15-1200 can also be used. Multiple panels require an additional RA-6 Daisy Chain connector.